Why chain link is the default boundary fence
Chain link is a woven diamond mesh of steel wire. It lets air and light through, keeps people and animals out, and costs less per running foot than brick walling or welded panels. A well-built chain link fence needs very little upkeep, which is why you see it around farms, layouts, factories, godowns, playgrounds and school campuses.
What makes the difference is the way the fence is built. The mesh is only as good as the posts holding it and the tension in the wire. Loose mesh sags within a season; properly stretched mesh stays flat for years.
Where chain link fencing works best
- Farm and plantation boundaries, including coconut, banana, mango and vegetable plots
- Residential layouts and vacant plots that need a clear, legal boundary
- Factory, warehouse and godown compounds, often with a barbed wire or concertina top
- Schools, colleges, sports grounds and playgrounds (see PVC coated chain link for these)
- Roadside, canal-side and temple land that must stay visible from outside
How we install it
Every site is different, but the sequence is the same. We follow it so the fence stays straight on uneven ground and does not lean after the first monsoon.
- Measure and mark. We walk the boundary with you, mark corners and gate positions, and note slopes, drains and trees that affect post spacing.
- Dig and set posts. RCC posts go into pits with a concrete footing, normally 2.5 to 3 metres apart. Corner, end and gate posts are fitted with angled struts to take the pull of the mesh.
- Run the tension wires. Horizontal wires along the top, middle and bottom hold the mesh in line.
- Stretch the mesh. We unroll the chain link and pull it tight with a stretcher bar before tying it to each post.
- Finish the top. Two or three strands of barbed wire, or a Y-arm with concertina, can be added where you want more deterrence.
Typical specifications
| Mesh opening | 50 × 50 mm is the most common. Other sizes can be supplied on request. |
|---|---|
| Wire | Galvanised (GI) for general use. PVC coated for coastal, humid or visible locations. |
| Height | Commonly 4 ft to 8 ft. Taller fences are possible with longer posts and extra bracing. |
| Posts | RCC posts with concrete footing, spaced about 2.5 to 3 m apart, struts at corners, ends and gates. |
| Optional top | Barbed wire strands, Y-arm with barbed wire, or concertina coil. |
What decides the price? Total running length, fence height, wire thickness, GI or PVC coating, number of corners and gates, and how easily our vehicle can reach the site. That is why we quote after measuring, not before. Send us your location and approximate length on WhatsApp and we will arrange a visit.
Frequently asked questions
How far apart are the posts in a chain link fence?
We normally set RCC posts about 2.5 to 3 metres apart. On slopes, near gates or where the fence turns, we reduce the spacing and add struts so the mesh stays under even tension.
Should I choose galvanised or PVC coated chain link?
Galvanised mesh suits most farms and plots. PVC coated mesh has an extra plastic layer that resists corrosion, so it is the better pick near the coast, around schools and playgrounds, and anywhere appearance matters.
Can chain link fencing be installed on uneven or sloping land?
Yes. We set posts to follow the ground and adjust post height and spacing on slopes. Where the ground dips between posts, we close the gap at the bottom so animals cannot slip underneath.
How long does installation take?
A typical plot or small farm boundary can be completed in a few days once posts are cast and the site is cleared. Large farms and industrial perimeters take longer. We give you a schedule with the quote.
